Plasma And Flame Pipe Cutting Machine manufacturer

Probleemid & küsimused seoses Nintendo konsoolidega.

Plasma And Flame Pipe Cutting Machine manufacturer

Lugemata postitusPostitas zhang123 » 11 Sept 2019, 05:30

Key Components Introduction
Chuck3 Jaws Chuck
Pipe support bracketScissors type bracketmanufacturer
Flame cutting torch1setmanufacturer
Plasma cutting torchHypertherm Powermax105Made in USA
Driving motorPanasonic AC servo motorJapan Brand
Driving control systemPanasonic DriverJapan Brand
Gear BoxSEWGermany Brand
Torch Height SensorPhotoelectric Height Sensormanufacturer
CPUIntel Pentium 1.6Gz
Touch screen10 inch Color Touch screen
RAMDDR2 1 GBMade in Taiwan
Hard Disk250GB
Operation systemMicrosoft Windows XPe/XP Pro
Network card2 x 10/100/1000 Mbps (RJ-45)
Power supply: 3×380v±10%/50Hz /220v±10%/50Hz(according to client's requirement)
Oxy-fuel cutting gas requirement:
Gas type: Propane/acetylene/LPG Working temperature: -10°C -45°C
Fuel gas pressure: 0.05-0.1 MPa Humidity: <90%, no condensation
Cutting oxygen pressure: 0.5-0.8 MPa Surroundings: Ventilation, no big shake
Pre-heat oxygen pressure:0.4-0.6 MPa
Plasma cutting Compress air pressure requirement :
Gas flew requirement:0.9m3/min
Gas pressure:8.3Kg/cm2
Dew-point temperature not exceed 5 centigrade:Oil content≤0.003ppm /solid particle≤0.01micron
Suggested using oil free air compressor, freezing dryer and ultra filter(system cannot have rust components)Plasma And Flame Pipe Cutting Machine manufacturer

Uus kasutaja
Uus kasutaja
Postitusi: 10
Liitunud: 11 Sept 2019, 05:28
Reputation: 0
Tagasiside: 0|0|0

Mine WII U, WII, 3DS küsimused & probleemid

Kes on foorumil

Kasutajad foorumit lugemas: Registreeritud kasutajaid pole ja 1 külaline


Konsoolifoorum on loodud aastal 2007. Alates sellest oleme saanud suurimaks konsoolide alaseks foorumiks Eestis.
Konsoolifoorumi e-mail:

Reputation System ©'